Mr. Heater Flame Sensor Kit for All Kerosene Forced Air Heaters

Excellent product - cheaper than the alternative that is made for my heater, and way better made than the stock one. The plug didn't fit my control board, but they included an extra pigtail for adapting to other heaters - so I just clipped the plug off of my old photosensor, soldered to the pigtail and plugged it in.Photosensor works perfectly and resolved my issue. Three thumbs up.

Fits and works great

same as oem parts

Ended up keeping for a spare replacement. Original was not bad. Needed to replace degraded fuel line, and my problem was solved.

Fit just like factory has extra plug for other type of wireing plug in make it run again highly recommend

This is the one you're looking for. Others I got from Amazon were far too short and did not perform as stated. This one is ideal; the leads were 15 inches long and worked well with my large Reddy heater.

This took 3 weeks to deliver. I have no idea why. Ive had stuff shipped from China show up quicker. Aside from that, the part fixed the problem of the flame going out and tripping the the breaker on the heater.

Quick fix. No issues. NOTE: you can’t just short this out to bypass it. It is required to see the flame. If the heater stops even when the flame us lit, you may have a spider nest in the sensor area. This fixed mine as mine had a nest in it, but after cleaning it out, the unit ran for about 15 minutes. After cooling, I got another 15 out of it.This part ages over time so it’s good to have a spare.