Guide Rail Adapter Compatible with Milwaukee Router - Made in USA

Just another great product by Milwaukee. Powerful motor, instant stop, great feel, easy to clean, 6 speeds. Just all round great router. Can’t go wrong with these guys.

Affordable and an amazing tool. I used it on my Milwaukee router on the track saw and the results were dead on and completely accurate without any tear outs.

The fit to the router plate was spot on. I have the MIlwaukee palm router and Milwaukee Tracksaw track.Like other reviewers pointed out the centerline triangle on both front and back are off by ~1/8th of an inch to the left of the Milwaukee palm router centerline marks on the router base that can be used instead.The fit into the rail does have a slight amount of play, but can be overcome by keeping pressure to one side while routing.

This guide rail adapter is one of the easiest to manipulate, clean, straight cuts with a router (Milwaukee) is what you will find. The product is sturdy and easy to handle with little to no effort. Cuts with router bits are unwavering and true to the wood products and all of the instructions to operate are easy to follow.

I bought the router and bits as well, and they all work so great together. Makes my job ten times easier and the guide saves me so much time! I have noticed a lot less mistakes on the wood working and touch ups that I have been doing. Would definitely purchase again.

I did not use it with the advertised circular saw tracks but used a Milescraft saw track instead. It wasn't a good fit but I glued the Milwaukee router mount to the provided stop piece which fit perfectly on the Milescraft tracks. So I managed to create a router guide with the Milescraft saw track by using the Toolcurve router mount glued to the Toolcurve stop piece which attaches to the Milescraft saw track.

The media could not be loaded. I really wanted to like these. I've attached a video clip for the stop, but amazon only allows one video clip per review, so just gonna have to take my word on the router base. so on to my review...first with the router base...it is super tight in a festool track, almost jerky, which doesn't work with routing where you need smooth motion or you're bound to ruin your work piece or lose a finger. Next, the stop. as you can see in the video, even when fully tightened, it slides easily...kinda defeats the purpose of a 'stop'. if only the router base slid like the stop did, and stop was as tight as the router base....then they would be usable products

Only flaw is the centerline triangle/arrow pointer does not line up with the centerline of router/bit. Think of a triangle pointer where the top of the triangle is supposed to point to reference, but the centerline is actually the bottom corner of the triangle instead. Not a big deal if you used a test piece first but annoying to remember every time. Since this item is cnc’d for a specific router, and I’m using that router, this should not be this way.Other than that, it’s steady within the track rail with very little deviance. That’s more important than any triangle pointer.