JandyR0013200 2 PSI Air Pressure Switch Replacement Kit for Pools

Used to replace old switch in Jandy pool heater. Worked great all summer expect it to work many more years.

Used this to replace a 17 year old original pressure switch. I used 2 cc of SAE 30 oil, wired it up and used Teflon tape on the fitting. While I was in the heater I took time to remove all the spade plug connectors and cleaned the terminals of corrosion using a flat file and 300 grit sandpaper. The terminals get oxidized over time and increase resistance at the connections. Take pics of the wires if unsure where to reconnect before you do that though. Overall job took an hour to do which included backwashing my filter element. I also checked the high limit switches to make sure they were ok. A multimeter comes in handy. This saved me hundreds!! Was facing $3500 installed for a newer JXI model.

This is the same part number as I needed for my Laars LD325P heater, but does not look like the part that it is replacing. The hole for the water tube is too small to insert the tube, so it cannot be connected. It also has a knob for changing the pressure setting, so it is not the 2 psi part that I need and ordered. I don't think this is a replacement for the Laars part number R0013200 as it says.

I chose this rating because this little item allowed me to have perfect operation of my Teledyne Laars 15 year old propane pool heater that the local gas line expert could not diagnose. After installation of a new propane gas valve for the heater, it still did not function, and I was told the valve was the problem and should be sent back. After internet searching and speaking with a Zodiac representative (new owners of Jandy), a techie friend and I found the old pressure switch to be defective. I purchased this from Amazon, installed it according to printed and Zodiac verbal instructions -- amazing, heater turned right on and has operated without incident since.As others have noted, the item actually sold and delivered is a newer version and not the white ceramic switch pictured here. Apparently the newer Jandy propane pool heaters do not need the oil in the line this switch is to be attached to. Zodiac technicians confirmed my heater needed the oil in the line, and to make sure it was a non-detergent product.

I ordered this item and found it didn’t include the brass fitting that allows you to mate the water line to the switch. Without that piece (as shown in the picture) you cannot use it. Be sure your part has that brass fitting or you’re wasting ur time.

The water pressure light of my pool heater kept blinking and the heater would not ignite. I bridged the pressure switch by a regular switch just to see if ti would resolve the issue and low and behold it did. Time for a replacement. I found this switch at Amazon and even though it looks quite different from the original, the reviews assured me that it wouldn't be a problem. I ordered and installed it in 10 mins and it works perfectly. I think it's even better than the original since you can adjust the PSI from 2 through 10. I use 2.

No surprises. I disconnected the old rusty switch and put this one in its place. Everything worked as expected without even needing to be adjusted.

Exact replacement for my Laars Lite 2 gas heater. It’s the OEM part just a new version like the picture. Worked and fit exactly like the old one. With the existing copper wire connection. Thanks !

Pressure switch functions as expected. Good price fast shipping! Reccomend buying from here.

wasn't sure if it would be compatible with my RayPak heater - the part looked the same - took a chance - and it worked. Very easy to switch out. Just threads in.

Used to replace the original pressure switch on my Laars Lite swimming pool heater. Installed in seconds and worked perfectly.

purchased the new pressure switch just to have ome on heater.

Works fine. Straight forward to replace and install.This version looks very different than the original part on the Laars Lite 2.This one has an ajustement valve on it.