Amarine Made4pcs Stainless Steel Cup Drink Holder with Drain for Marine Boat RV Camper

These were a perfect fit to replace the plastic ones in my Premier Pontoon.They fit great in all four locations I replaced. These are better than the stock ones and come with a drain you can keep open or closed. These are a nice upgrade at a great price!

Nice. Very good price for these at this quality level. The double sided tape provided is a joke, use marine sealant. But still, very good.

These are replacing my old white, faded ones on the boat. Fit, look and work great.

Fit my Honda pioneer 1000 dash good . Easy to install.durable material.

Can’t beat the price and it looks good but is cheap stainless steel, and after three years it started to corrode a little

These were perfect replacements for the plastic holders on our boat. They look so much better.

I think I've purchased 14 of these stainless steel cup holders over the last 2 years for various boats and they're all in perfect condition. They fit the standard hole size perfectly. If you’re creating a “standard hole size” you’re looking for a 3 and 5/8” hole saw. If you’re going to be drilling into fiberglass, here’s a few tips:1. Put painters tape down over the are you’ll be cutting out. It’ll help keep the drill bit from wandering all over the place and scratching up that gelcoat you work so hard to keep clean.2. If you’re using a standard hole saw bit for your drill, it’ll have the standard drill bit in the middle along with the big honking hole saw bit on the outside. Once you drill through the gelcoat with the center (smaller) drill bit, put the drill in reverse and let the drill back its way through the first layer of fiberglass before switching it back into forward to remove all the bulk of it. Running it in reverse first will lesson the chances of it cracking and spidering out everywhere. It’s typically a much cleaner cut.3. Run the drill in low speed. You’re removing a bunch of material so don’t go heavy on it. You’re likely to overhead the bit and the saw will lose its temper (both literally and figuratively).These cup holders feature a nice drain hole on the bottom. When necessary, I ran clear tubing to a drain hose or to the deck and attached it with a stainless steel hose clamp, although I don’t think it would have come off just by the pressure it took to slide the hose over. If you got a size too small in the hose department, take a lighter or a heat gun and heat it up for a bit until it’s loose enough to stretch around the drain.Overall these things are an absolute steal and they enhance the look of any boat. Get ‘em while you still can at this price!

These look great in my boat and replaced the OEM black plastic holders that were discolored from fish innards and soda. Great looking and should be easier to keep clean.

Exactly what you're hoping they are going to be. Well made, good quality and a nice weight. Just installed them so can't comment on longevity but they appear to be something that will last. If you're looking for a nice combination of quality and value, this is it.

Excelente producto muy contento con él

Buon prodotto

Arrived early Nd in good order, quality, thank you.

Muy buen producto