Englander Summers Heat Timber RIdge Pellet Stove & Grill 4.75" Heating Element Igniter - Replaces PU-CHA

1. You might want to take the round spacer or whatever off your old unit and use that since the one on these are a bit too large for the hole. Worked for me and no grinding down necessary2. Make sure when your lining it up, you leave a decent air gap between the end of igniter and the hole it comes out in chamber. You'd think closer is better but it actually really needs the air gap and air flow to work

item is good but collor didn't fit as described had to use old one

Fits and works as it should.

We installed in November and it worked great until Feb. I ordered another and I hope it lasts longer

works fine. this is a replacement one. the first one lasted 1 month but not the fault of the igniter. the burn pot gasket was faulty causing the igniter to burn out. replaced the gasket and put in a new igniter. works great. the only other issue was the locking collar was to large. used the old collier. no issue.

Item arrived as described in a very timely manner. Fair price. Works good.

Starting my pellet stove. In this below zero temperature it worked perfectly.

The adjuster ring towards the top will not fit in the hole on an Englander 25-PVDE pellet burner....it's too big. I had to take the one off of the old one and put it on the new one. Then.... we had to shave the adjuster ring down (thinner) with a belt sander because the collar is welded on the ignitor, which makes the ignitor about 1/8" too short. Hopefully, it doesn't effect how it works. This is the correct part number listed in the manual, so it should fit without a problem!

J'ai du utiliser la bague de mon ancien allumeur automatique pour l'installer dans le troue du poele. La bague de l'allumeur était trop grosse de 0.015"

so far so good, fitment was good and so was the price, shipping was a little longer than I hoped for