Rugged RidgeDeluxe Carpet Kit for Jeep CJ/Wrangler YJ | Polypropylene, Black | 13690.01 | Fits 1976-1995 Jeep CJ & Wrangler YJ

I did a lot of digging into different brands before I went with this one. For just shy of $300, it was in the middle of the price range. Yes, you will have to make cuts and holes but you should know this before going into the project. I also got 2 cans of Permatex headliner adhesive. I installed the pieces in the order on the directions and it ended up looking great (for a DIYer). I took pictures of each area before I glued them down and I would use nailed to find the holes. Once I had the holes marked out, I used a soldering iron to make the holes and it would melt the threads so they wouldn’t unravel. The adhesive said to spray both sides for best results but that made it extremely difficult to reposition the fabric. I found that spraying the surface of the jeep and immediately putting the carpet in place worked best. The toughest area was the front section. Cutting around the shifters was a pain but just use stay calm and make small cuts. I had to cut a good chunk off the very front so it wouldn’t interfere with the pedals. Overall, the quality is great, the price was worth it, and I would def get this product again. On a bonus note, the Jeep is so much quieter now that the carpet is installed!

I purchased this to replace my 20 year old molded carpet in my '95 wrangler. Fit was absolutely terrible. I didn't realize this would not fit until after I had to cut holes to make fit. At that point, I was committed. Besides terrible fit,, the quality of carpet was not good. When it said "Deluxe Replacement" I expected a carpet that was a step up from my original carpet The quality of this really bad.Bottom line, I could not return since I cut to fit. I ended up re-installing my old worn out carpet and threw this product in the trash. Worst $159 I ever spent.

What an improvement. It was about as easy to install as possible considering how many cuts is required for seats, shifters, and other penetrations. I use a good pair of scissors and occasionally a box cutter. The advice by others to use the Permatex 27828 glue was right on. One 16.75 oz. can is more than enough.

Jute pad was pretty thin, I added more jute pad. fit was not perfect,even after adding the extra jute pad it was still very loose around the transmission tunnel.

Seems to be quality material, good fit, no cutouts or guide holes like other products, but it is a good bang for the buck and installation was fairly straight forward once all seats and roll bars were removed. This isn't a quick replacement.

A very good quality product with good padding in all the right places. Every Rugged Ridge product that I have purchased has been of good quality. Very pleased!

Several reviewers complain about a bad fit but for my 1990 wrangler it was tailor made. Edge to edge without a problen even under the seats and front floors. I had to cut out the shifter and one small slice for the gas pedal. That was all. While an adhesive is recomended, I used velcro "tacks" during installation. I removed all seats and anchor points to install so screws, roll bars, and brackets hold most of it in place. I will probably switch to a more permanent solution later but only if the velcro fails or carpet stretches. Carpet has padding attached and is easy to cut. Highly recommended if you have a 1990 jeep wrangler like me.

Adhesion is near impossible because the carpet is too large in some spots, too short in others. Trying to get it to lay flat and fit well was really difficult. In many cases you need to cut finished edges in order to fit which leaves ragged edges unraveling. Value for the money is very low. Carpet quality is ver low, if I did it again I’d spend more and get a much better kit.