DC 24V Step Down to 12V 30A 360W Converter Voltage Regulator Reducer Buck Transforme

Works great to reduce the voltage on my golf cart to power LED under lights. Would buy again if I needed one.

Good place to buy from.

I upgraded my 1995 EZGO TXT Golf Cart from Lead-Acid to a new 36v Lithium Battery Pack. I purchased this power convert to run my two LCD headlights. It was easy to connect and works great. The instructions, illustration card in the box, and labeling on the converter were correct and easy to follow. Several reviews say the labeling and/or instructions/illustrations are incorrect, so the manufacturer must have made corrections, as mine were correct and everything is working as designed. On mine, the red wire (with inline fuse) and black wire on the input side go to the 36-volt battery source (red +, black -), and the yellow wire and black wire on the output side go to the source to be powered by 12-volt (in my case, the lights) (yellow +, black -). It looks nice and is well-made. I would recommend this product to others.

After 3 months still going strong with daily use. I purchased for my ebike to add 12 accessories at first I was leary and wasn't going to purchase after reading some reviews but I decided to cause I got to thinking, like most other electronics someone bought it and installed it wrong or overloaded it fried it an blamed the product, so bought and did a bench test with a voltmeter before installing and everything is still working great. It gets warm but not to hot to touch but its also exposed to a lot of moving air and and on average im only pulling have the amps then what its rated for.Tips when purchasing a buck converter:1- Buy a higher rated one then you need for 2 reasons. If all your 12v devices pull 20 amp when they are powered on get a 25-30 amp rated not a 20. First is in case you have a power surge and second it won't run as hot cause it won't be under full load.2- Make sure its wired properly, some people look at it and go "2 black negative wires and connect the 48v and 12v negative together and connect it to 48v negative power supply. Then have all the 12v devices negative tie into 48v negative. That not recommend even though it may work temporarily or fry something instantly depend on how everything else is wired but will eventually fail and can cause serious damage......especially if 48v- backfeeds to 12v- and fries buck converter and shorts 12v and/or 48v system.If not overloaded and well ventilated and wired properly it should last a while.

wires too short

Great

Everything was fine. Installed easily and worked fine for the first few days. On my second night out it decided to short out and sent 48 volts to my LED lights and out they went. I saw this happened on a small percentage of the reviews and decided to take my chances and dang if it didn't happen to me too. It is unfortunate that they sell all this junk without having anyway to know who makes a good one and who does not. Buy American!

The 3” x 3” card that comes in the box shows the correct connections. The online document mixes up input / output terminology and power supply and load terminology..Expect a good spark when you connect the red and black wires to the battery source power even with no load connected to the 12V output yellow and black wires.Works fine and seems to have little or no idle current draw on the battery source.