IntegyRC Upgrades for Traxxas 2WD, Billet Machined Wheelie Bar for Traxxas 1/10 Stampede 2WD & Rustler 2WD

The media could not be loaded.  Best wheelie bar for the money. The only reason this product has bad reviews is from people not following instructions. Integy clearly states in the description that you need to Loctite all the screws. Just like ANY time you have metal to metal and 90% of tires you by are not glued and you have to glue them. Just like this one. The only negative thing I can say is that the tire has flat spots and high spots and is not completely round or treaded at all. But this is a all aluminum wheelie bar for under $30...what do you expect. Lowest setting (since this IS adjustable) makes my 3s 9000 mah rustler fly on two wheels down my entire street. Update I went to my local hobby shop and replaced the bolt for the wheel and added bearings much smoother also Tire did wear straight after a few runs

I would recommend this wheelie bars to other hobbyists, but would also recommend that Integy improve its design.I much preferred the look and quality of this wheelie bar over a lot of competitors including Traxxas itself- I hate throwing more plastic on my Rustler. This wheelie bar would seriously benefit if the rubber came preglued to the rim from factory. That feels like a given and not an afterthought on the customer's behalf. I also haven't seen any replacement wheels available for this particular unit, so when it comes time to figure out a replacement wheel down the line it might be a real headache.On positive notes, I love the chassis mount method as opposed to bolting it to the transmission case- it looks better and is less likely to damage the trans case in a wipe out.The height adjustability is nearly unparalleled, and you can either set it to do 45 degree wheelies or practically have it down to the ground to put the power down, and anywhere in between.It has its negatives but more positives, feels like a decent investment though

By and large, Integy billet machined products are sturdy and durable. This wheelie bar is good quality, but it has a couple of notable downsides. The first is that the single wheel is a little unstable when executing a wheelie. Two wheels might offer better stability. Secondly, the tire keeps shifting off the rim. It happens every time. I'm considering gluing it in to place, but that really shouldn't be necessary.

The media could not be loaded.  Great Wheelie Bar. Awesome to have balance while pulling wheelies. The Traxxas Wheelie Bar is garbage.FYI: I am using Proline Tranny on my Rustler.Only needs some Glue on the Tire and Loctite on the screws. I don't consider this a real negative as were are hobbyists, capable of correcting these small flaws. Nice bang for the buck and a MUST HAVE.

Installed the wheelie bar, made one run and the rubber came off the wheel. So I put a touch of glue so it would stay. Took it back out made another run, turned around and the truck nearly did a back flip. The screw holding the wheelie bar together is completely gone. Keep in mind I never touched this screw, checked the others and two more were loose. I absolutely wouldn’t recommend this to anything. Great waste of money

Make sure you install it correctly. Add threadlocker to screws and use CS/superglue on wheel like you would any other part on your car. Don't be a noob.

Pretty sweet looking setup but, it's really heavy and will slow your vehicle down. I had a good idea that it would and purchased it just for a Stampede to wheelstand.

I had replaced enough plastic Traxxas parts that I refused to buy a plastic wheelie bar. Read the guidelines and reviews for this item-glue the mounting screws in. Glue the wheel on the tire on. This has been very durable and does the job

Not cheap but Excellent quality!! Running a car with 6s li-Po and plastic can’t handle the job.

Made very well, but way to heavy